Page 2 - air-fuel-ratio-monitor
P. 2

LM-1 Installation

                                    To a switched and fused 12V power source

              DynoTune                                                                     LM-1
               Display                                                                   Wideband
                                                                                        Controller

            Brown wire
                                                                                      3.5mm Analog
                                                                                      output cable
            Blue Wire                                                                 Bare Copper


                                                                                      3.5mm Analog
                                                                                      output cable
            Black Wire                                                                White=out 1





                   Note: Your LM-1 should be setup so the output is 0-5V

                   The White wire on the monitor is not used.






               DO NOT LEAVE THE TERMINATOR PLUG  INSTALLED IN THE “IN”
               CONNECTOR WHILE OPERATING THE LC-1, ONLY WHILE
               PROGRAMMING IT! KEEP WATER OUT OF THE “IN & OUT”
               CONNECTORS!
   1   2